Skip to main content (Press Enter).
Skip auxiliary navigation (Press Enter).
Terms and Conditions
Skip main navigation (Press Enter).
Research Working Groups
The Inner Circle
List of Contributions
Operation of temperature and humidity chambers is explained in great detail in the Operations Manual of the GSA (General Service Administration). It's the most general manual for operations associated with temperature and humidity management. It was printed in 1970. The principal purpose is to prepare an environment that's free from hazardous conditions, thus allowing controlled manufacturing. There are specific requirements for temperature and humidity chambers based on the GSA.
According to the GSA, all temperature and humidity equipment and components should be properly and safely installed. The temperature controller, thermostat and some other temperature or humidity controlling device should be correctly maintained and installed. It is best to always have your gear inspected periodically by authorized personnel. Before you leave for a visit, it's very good to check if your equipment is functioning correctly. If you discover any issue, you must report this immediately. You should immediately moisturize the affected equipment and eliminate the components in a suitable way.
If the manufacturer is a certified company, you'll discover certain instructions on the manual which have been issued with them. However, if your manufacturer is not a certified company, it's highly encouraged you don't utilize their equipment unless it's been tested for security purposes by licensed personnel. You should not use them for anything that may break down or damage the equipment. Failure to follow these instructions may cause severe consequences.
The tech must track the pressure in the chamber to make sure that the machine is maintaining constant room temperature. This also leads to premature failure of the gear. In addition, it impacts the growth of the employees from the manufacturing units. Improper operation of the chamber leads to the accumulation of moisture within the system which impacts the quality and performance of the products manufactured.
The first instruction that's given in the manual issued by the manufacturer instructs you to fill the water tank with distilled water and also to close the valve. This is followed closely by the procedure to set the temperature and humidity controls. Following the alteration of the controllers, the very first test is done by placing the device at room temperature. The testing is completed once the water starts leaking and steaming. If the steam starts flowing and it looks dark, the chamber is brittle and you ought to replace it with a brand new one.
There are a number of other techniques which are followed closely by the producers in order to set the temperature and relative humidity controllers. However, it's highly suggested that the temperature and relative humidity ought to be controlled using just 1 control valve each pressure equalization valve bundle. If some two control valves are used, it can result in erroneous readings. If the pressure is uneven, the readings can also be wrong. Therefore, please follow the specific instructions given below.
In order to produce the temperature and relative humidity completely controlled, the temperatures and relative humidity shouldn't exceed 40 degrees Centigrade. Furthermore, all the equipment used in the process of measuring these values must be calibrated and tested before using them for working the machine. If there aren't any problems encountered while implementing the above mentioned instructions, the best alternative is to speak to the manufacturer and talk about the possible rectifications. You could also send your request in writing. A fantastic communication skill will help you a whole lot in keeping your business operations into the best level.
It is best to modify the operation method as per the requirement if you do not find the results you anticipated. Thus, whenever you begin a new performance, you must explore the probable changes with the manufacturer. He will help you figure out which procedure needs to be followed closely for measuring the temperatures and relative humidity. Once you understand the significance of the techniques, you can easily begin measuring temperature and humidity with the help of the surgery techniques of
temperature and humidity chamber
. With luck, this report will help you to get maximum advantage from your recently purchased apparatus.
Copyright 2020. All rights reserved.
Powered by Higher Logic